For the price they seem to be a good cutter.I have only been using on mild steel and aluminum ,and am happy with them

For me they allowed me to cut out thin pcs without difficulty for finer workmanship. I know they have multiple uses.

I do alot of 3d cnc milling on walnut. This bits are sharp and last along time. They leave a amooth finish and get into thoughts hard to get spots. Ive tried some other brands and these are the best I have found so far

Very decent for the price

Used them in a bridgeport to round the corners off of aluminum trim workedworked fine no issues.

Works great have used it on a benchtop mill cutting mild steel with no issues.

These millends are good quality and do well for my projects I mill on my CNC. I would recommend them and will update on the life of the bits once I run more projects.

They are good. Used on dremel at 35k RPM on tough stainless. Depth of cut is always key

Was pleasantly surprised, manual jury-rigged setup with a spindle motor clamped on a lathe, cut well, didn't chip or snap. Tested on steel and aluminum.

These end cutters keep a sharp edge for a use on multiple metals

Got the job done

So far im surprised no issues used on mild steel

Product description is 100% accurate.

Sharp end mills with uniform coating for durability. Sizes are all correct when measured with a micrometer. They are individually packaged to protect them from damage in transit.

So far they have worked very well on aluminum.