For the price they seem to be a good cutter.I have only been using on mild steel and aluminum ,and am happy with them
2026-04-20
jeff andricci
Used them in a bridgeport to round the corners off of aluminum trim workedworked fine no issues.
2026-03-31
Kevin Brown
They are good. Used on dremel at 35k RPM on tough stainless. Depth of cut is always key
2026-03-16
erischilde
Was pleasantly surprised, manual jury-rigged setup with a spindle motor clamped on a lathe, cut well, didn't chip or snap. Tested on steel and aluminum.
2026-03-14
Weekend warrior
These end cutters keep a sharp edge for a use on multiple metals
2026-03-05
David
Got the job done
2026-02-27
Rex Williams
So far im surprised no issues used on mild steel
2026-02-11
jWow
Sharp end mills with uniform coating for durability. Sizes are all correct when measured with a micrometer. They are individually packaged to protect them from damage in transit.
2743489